Originally Posted by
jjjheimer
Ok.. yes I have a little more toe out on one side than the other.. camber if off by a little bit as well. I'm going to double check I used the right lower control arm pin mounts, then borrow a setup station and dial it all in.
Get all your links (Camber and Steering) equal and check again using set up tools or set up wheels at the least. the plastic wheels we race with seem to have a bit of run out normally so any measurements with those will be inaccurate. Things should be pretty close at that point. As you change camber the toe will change a bit as well so if the camber is not equal the toe will likely be off a bit as well. Even with all the links equal right to left you still might have to adjust a tiny bit but there shouldn't be large differences left to right unless something else is messed up. Good luck.