Originally Posted by
Marcika
Hi,
Quick "greener" question :-). thx for the comments in advance.
1. how much "spacer" should it put under front pivot block not to have anti-dive if I replace split mount with fix in the front-rear (1Xb to B). As a kit set up, there is 0.5-0.5m.
2. If you run on very high grip carpet - using front: white, rear blue tamiya springs - what oil would you use to "loose" some grip since car is oversteering can roll over :-(. I used 450#. front dampers in the 3rd hole, rear in the 5th..... I felt my car too soft.
Thanks
Marton
with a solid in the front inner block position, 3mm would equate to no shim under a split block. Adding 0.5 (total of 3.5mm) would be like 0.5 under a split block.
The over steer and over roll will be caused by your shock positions...
Stand your front shocks up to hole 5 , and lay your rear shocks down to hole 4. If that doesn't fix the over steer then go up in shock oil to 500.