Hi guys! Here is the setup I ran at the ROAR region 1 championship:
Shocks:
- RCShox lightweight shock towers front and rear
- RCShox 2 stage pistons all around, bigger bleeder hole on caps all around
- Serpent GT Purple springs in front, 800 WT shock oil (AE), outer hole on lower arms, middle hole on tower.
- Serpent GT Red springs in rear, 575 WT shock oil (AE), outer hole on lower arms, inner holes on tower.
Chassis:
- ride high 8mm rear after pushing down, 7mm front after pushing down
- + 1mm hex front
- +2mm hex rear
- 3 degrees camber rear at ride high
- 2 degrees camber front at ride high
- Front toe is between 2 degrees out and 0
- Rear toe is 3 degrees
- Stock anti-roll bars front and rear
Differentials:
- 100 000 CST (AE) Front
- 10 000 CST (AE) Rear
Front Roll Centers:
- Inner hole on caster block with Aluminum 10 degree caster block
- Outer higher hole on tower
Rear Roll Centers:
- Outer hole on C-Hub
- Inner higher hole on tower
Engine, Gearing:
- Novarossi Keep-On with Off-Road head
- 17/20 Pinions on clutchbell
- 45/40 Spurs
- 10/43 Bevel gears
Last edited by Joe Kimble; 10-01-2013 at 07:42 PM.