Kevin K, I have tried the outter hole on the arm and the middle on the tower with Losi purple's. Car felt good, but did not carry the speed. Did you still lay them down, but used the outter hole? I have not tried that yet. My car feels "GREAT" right now. Here it is:
FRONT:
#2 Associated w/ 80 weight oil
TC3 white spring
inside hole on arm and inside hole on tower (laying down)
2 degree inboard toe out
8.5 castor
outside hole on hubs
thick sway bar
3mm droop (3 on Losi gauge)
0 toe out at wheel
REAR:
#2 Associated w/ 80 weight oil
TC3 white spring
inside hole on arm and inside hole on tower (laying down)
0 degree inboard toe
2 degrees of toe in at wheel
outter hole on hubs
stock upper mounts
middle wheel base
plaids/purples
Nothing done to roll center or kick up (STOCK)
Car still needs to be a little stiffer. Going to go to #3 pistons for this weekend. I kind of think the car carries more corner speed using the inside hole on the hubs. Going to experiment more with that as well. Overall this is an easy to drive set up for stock or mod (ESPECIALLY STOCK). Still working on getting 100% in mod. It's close.....
Rob Love