I have noob questions again.
I understand front ride height can be adjusted with spacers under front spindles. How to adjust the rear? I thought it was with the roll springs on the sides.
Also the preload on the coil over damper just adjusts the angle between the front and rear pieces of the chassis correct? You always want both pieces to be flat (parallel to ground) with that preload correct?
Also what would be a good ride height/springs/oil/grease for a track like norcal hobbies (I got pit shimizu tires from them soft front and hard rears).
My stupid 21.5 tekins not yet shipped it was out of stock on amain so had to order from Tower so I might just have to practice with a 30% EPA 7.5 motor I put in the car.