Originally Posted by
daang
The raceberry one
So in other words your bending your top deck? The raceberry kit comes with 1.5 mm shims to go under the top deck (this is to go with v5 bulkheads), the yokomo motor mount that screws into the top deck is 1.5 mm higher than where the top deck screws on the v5 bulkheads.
If you were not running raceberry, there is no reason or to shim up the top deck. Best to keep it as low as possible. The only other acception is the kentech mod which requires you to shim up the top deck so the motor bulkhead isnt secured down by the top deck.