Hey guys I'm after some advice on my motor/esc. I've just completed my first kit build (SCTE 2.0) which I gotta say was a pleasure to build! Top quality product, can't wait to run it!
I've just finished installing a Tenshock 120A ESC and Tenshock SC401 3800kv motor. I have soldered the wires and installed the receiver etc. I hooked everything up and switched on the whole show. I have bound the radio and the servo works fine. But pull the trigger and nothing from the motor. Am I missing something totally obvious guys???
Could it be: incorrect wire positions/new battery not charged enough? (Wasn't totally charged but I plugged it in just to test if things were working)
I'm new to this and like I said, this is my first build so it could be something simple and dumb, please help guys, anything would be appreciated! (No LHS in my town!)