Thread: TRF101
View Single Post
Old 07-24-2013, 08:24 PM   #534
Autocratic
Tech Master
 
Autocratic's Avatar
 
Join Date: Dec 2011
Location: Dallas, Tx
Posts: 1,690
Trader Rating: 26 (100%+)
Default

Just got done something some maintenance, and noticed my diff housing is bent. I've actually had some bad wheel vibration since I built the kit but thought it was tires. Even after balancing the right rear tire has a bad vibration. The side of the diff that is bad is pinned to the shaft.

Any chance getting Tamiya USA to replace the shaft/housing? Or am I out of luck and need to buy a whole new assembly?

Side note, also checked Tamiya USA site again, and it does say camber adjustment 1.5/2.5, but that's just bogus. With the mark on the inside I'm right at 1.5. Outside is barely a 1/2 degree, which was actually wearing the outside of the tire and leaving the inside still shiny after several runs.
__________________
Thanks to my sponsors for 2015!
XFactory RC | Proline Racing | Fantom Racing | Avid RC | Speed Passion USA | Factory1 | Hy-Traction Juice | Mike's Hobby Shop
Autocratic is offline   Reply With Quote