Originally Posted by
urluzn
Hey guys, just built my 2.0 and I notice I have a slight bind in the front diff. Its free 3/4 of a turn then binds the rest of the way turning the front drive shaft. I took it back apart and it turns free in the housing but once I put it back together complete it does they same thing... Even tried loosening the screws a tad. Still the same. Anyone else have this problem...
First Post Woo Hoo..
I had the same issue. I finally figured out that the bearings weren't pressed onto the case tightly enough. I used a large pair of channel locks, carefully, to snug them up by pressing around each side a little at a time until they were completely snug.