Originally Posted by
Potoczak
Stock set up had my rear end loose so I put 1.1 mm rear sway and laid the rear shocks 1 hole and stood up the front shocks one hole. The handling was better but the springs were too hard for me so I put tamiya white med in front and soft in the rear. The car is fast.
Originally Posted by
JimmyMack12
RE: Back to the S1:
Haven't even run the car yet; just finished getting the chassis together. Adjusting the rear end (camber), and *snap*...the right rear ball stud snaps off with the threads deep inside the hub carrier. :/ So, now I need to (already) get a new set of rear hub carriers and ball studs (no extras, and the ball is bigger than what I run on my oval pan car).
Are the ball studs in the S1 kit *that* brittle that I should consider replacing them already, before I even get a chance to run it?
I didn't break mine but had trouble with the ball stud on the same part on my r1.