I just picked a competition V3.0, 17.5R/Reventon Stock Club Race ESC combo to run in the Spec R S1 I am building. I also bought the LED programming card at the same time. I have downloaded the PC interface software (v1.1.0.22) and installed the USB drivers. I have been able to get the software to recognize and update the firmware on the LED card to V1.4 and I can connect the card to the ESC and read/program some of the variables but cannot get the PC software to work with the ESC, (via the LED card).
What might I be doing wrong?
btw, the computer is using win7 32bit.
Thanks.