R/C Tech Forums - View Single Post - Speed Passion F1 car - The SP1
Thread: Speed Passion F1 car - The SP1
View Single Post
Old 05-27-2013, 12:26 PM
  #339  
InspGadgt
Tech Champion
 
Join Date: Nov 2001
Location: Hawaii, USA
Posts: 7,191
Default
Originally Posted by Walkman
Be really careful on step 19. The plastic capture insert for the pivot ball going into the steering upright. the insert is really soft. If you do not take your time and be careful you WILL strip it out and your done. I would suggest you download the manual from the website and look back through this thread and follow the step by step build guide by liljohn1064 on page 9.
Cut a slot in the insert with a Dremel and use a flat head screwdriver instead...works much better than the the plastic hex.
InspGadgt is offline  
Reply