R/C Tech Forums - View Single Post - Xray T4 '13
Thread: Xray T4 '13
View Single Post
Old 05-23-2013, 12:55 AM
  #3699  
martinskarin
Tech Apprentice
 
Join Date: Mar 2013
Location: Shanghai
Posts: 64
Default

Originally Posted by JOE SI
Check droop, ride height and shocks. Just sounds weird being loose on corner exit and push on fast corners since most of the time they're both on throttle.
Originally Posted by niemand
Hey guys,
I am totally lost setup-wise. I hope you can help me.
Im running on a small and rather tight asphalt track with low to medium traction.

My setup:
Base asphalt exept for
1mm rollcenter spacers on the bulkheads instead of 2 mm (front and rear)
rear shocks in hole 3
0,5 degrees of arm sweep front
Protoform Mazda Speed 6 body (LTCR already ordered)
Ride Re32
17,5t boosted or 10,5t

My problem:
I just dont have enough traction.
Loose rear end on corner exit, massive understeer through fast corners, slight understeer in medium speed corners and massive understeer in slow corners entry to middle.
I also drove a Tamiya teamdriver's car and his 417 v5 was just that much better so its not the trackconditions in general. He didn't even use the raceberry conversion kit

Tried a lot of stuff already, nothing really worked. So please help me. Any ideas are welcome

Regards,
David
Try my aoc setup. It was a super technical track. Adjust rear difr oil after grip level.
If you still have problems try make the car softer and make it roll more.
http://forum.teamxray.com/xform/inde...D=361&setup=t4

I ran the 17.5 blinky class that race.
martinskarin is offline