On the setup sheets next to the pivot block they have markings of 1, 1.5, 2, 2.5 and three. I see for the front block the 0 is circled and for the rear block the 2 is circled, am I supposed to have a 0 degree toe-in block in the front and a 2 degree toe in in the back? I guess the first question I did't state very well was does HPI make a 1, 1.5, 2, 2.5 and 3 toe in blocks? If so then I must be missing the 1 and 1.5 toe-in blocks. I mainly race on carpet.