Originally Posted by
gelshocker
Personally I would not put a ti screw into any metal, same reason I don't run lunsford ball studs in the expensive alum hubs.
Iv been running lunsford Ti ballstuds in my kyosho aluminum for a long time, and have never had an issue. I think the lunsford Ti ballstuds are FAR stronger than the stock ballstuds, and would HATE for one to break off in the aluminum... so I personally consider the lunsford Ti ballstuds in the rear hubs a MUST HAVE. (same if running the alu rear upper bulkhead)
I don't use Ti screws though.