Couple things I noticed today.
- When putting in the crescents for the ride height adjusters they need to face the same direction or the axle gets slightly misaligned. And by same way I don't mean both facing in or both facing out but both facing left or both facing right.
- In the addendum included with the instructions it shows two 1mm spacers to put in the rear wheels to space out the rear axle to 190mm. Mine did not come with those spacers. Was it supposed to? That aside...Looking at the left rear hub if you put 2mm of spacers in the wheel it is going to pull the wheel off of the inside hex so there will only be the 1 thin outer hex aligning the wheel. A better option would be to use axle spacers but to do that we'll need to widen out the flat spot a bit more on the axle.