Originally Posted by
rifraf
Nosir,I have all the kit screws.Looks like the supplied 3mm screw is too small for the hole in the captured in on the steering link,like the hole in the rod end may be 5mm..this area has the steering slop i am referring to..
First off, there are no 3MM or 5MM screws on the SCTE - it uses American standard hardware (except in the diffs).
That said, it is possible you used a ball in the steering link meant for a 5-40 screw instead of the ones that are supposed to go in the steering link which (the balls) are meant for 4-40 screws.
The balls are the same outside diameter, so it is possible to fit the wrong ball in the steering link. But then you will find that when you use the 4-40 sized ball in the place where the 5-40 sided ball was supposed to go (because you got them mixed up), that the 5-40 screw won't fit through the ball.
This is all assuming you are talking about the link that connects the servo arm to the servo saver.