Originally Posted by
6376vette
Front cover is outer hole. there is only one hole on the front c hub so your kinda stuck with it.
It could be your problem. you have your front roll center pretty low with a 3 mm shim. pull the front shim and leave the rear and see now it handles. If it begins to push a little or the rear feels really slugging drop the rear shims down to 2 then to 1.5 then to 1 and see what you like best. a low roll center could also contribute to your traction roll. Sounds like the front is just biting in too hard. you could also try harder front springs and less rear droop to keep more weight on the rear under braking.
I will try this :-) thnx a lot. Learning much now.
What about belt tention rings? Do you run them up or down? Learned from the manual of my xray that this infact change traction too.