Originally Posted by
Casper
I still don't understand how you guys are stripping hardware. Is it the hex interface? Are you using "L" wrenches or what?
I have yet to strip a screw on the Ten or 8ight series. They both use the same 5-40 hardware.
The small screws for the diff are a bit of a long job to thread in ,I am assuming people are just rushing the screws in and causing the tip of the tool to wander.Slow down and take your time on those screws guys.
Also go spend 26 bucks on the MIP tools(2 ea) that are needed for the shock cap bleeders and the diff screws and You will never(going slow and takin yer time)
strip a screw..