R/C Tech Forums - View Single Post - TLR TEN-SCTE 2.0 Kit Thread
View Single Post
Old 03-13-2013, 10:37 AM
  #1897  
Purdue Engineer
Tech Regular
iTrader: (8)
 
Purdue Engineer's Avatar
 
Join Date: Oct 2008
Posts: 407
Trader Rating: 8 (100%+)
Default

I am using the same setup Ryan had posted on page one of this thread. The only thing that I changed from his setup, is the ride height.

Casper: The track is a med size indoor track. It is hard packed clay/dirt mixed and it is kind of bumpy. I talked to people there yesterday and some say run soft and others said you have to have clays. Pretty much any small pin or bar type tire will work. I see you said the #3 pistons on the front with 27.5 oil. I was in a rush to get it done so after the plug fell out, I put the #3 with 30 oil in the rear.

I'm going to redo all four shock. I am going to put the pistons in acetone to clean them up and then start over. This time, no tooth picks and will use accelerator. Between that and putting clay Rattlers or IONs on, I should be good. I'll also look into the front camber link position, but that will be an "at the track change".

Thanks
Purdue Engineer is offline