Originally Posted by
20967
I have e new question about the droop regarding TC6.1 WC my new car.
I use actually the old TC6 and for measure the droop nothing problem for me. In the TC 6.1 and in WC front and rear arms are bigger respect TC6. I am not sure about the correct position to mesure the droop in the new arms readind this to pag. 27 " The standard settings of 6mm front and 5mm rear will work best in most cases. Droop is measured just underneath the outer hinge pin as shown in the photos to the right."
In the foto the measure is under the arm but not under the hinge pin........
Can help me?
Enrico
I find that using a measurement tool is only useful for the initial setup so that all arms are at equal droop settings. I will then prefer to measure from ride height as I feel this is more reliable in terms of a real adjustment as it is based on how the car sits under driving conditions. So just pick a common spot on the arm and make them equal to start. You can bias the setting a mm or two from front to rear if you choose.