Originally Posted by
20967
I have posted this question here,(
http://www.rctech.net/forum/electric...hread-588.html) but without any reply.
This is a question:
" I have a question about Arm Mount. I noticed a lot of gap in the Arm Mount hole where the hinge pin is insert in them, this also after fews race.
This gap is more or less higher and different for each supply where I buy.
Is normal or not?
The "PPD Billet" is good, but do not have the choice of new offset and not easy to set up.
Any help is appreciated"
I can help.
Thks
Enrico
Hello Enrico,
I did noticed as well but usualy the aluminum insert are all the same lenght or you can also measure to make sure but when you tighten the arm mount onto the bulkhead, I usualy tight it untile I can feel the alumum insert touching the bulkhead so at this point the gap does not matter anymore if that make sens !