Originally Posted by
jimjav
I am having some issues during the built of the eryx,
I have too much side to side movement in the midle axle, I am talking about 2 mm, I have also the same issue in the spool. For the spool I have try another set of eccentrics that I have as spare in my toolbox and the results is the same. For the middle axle I will tray another sets of bearing but I donīt belive that this will resolve the problem
Anyone has the same problems? Ideas for solution?
My first impresions abour the few things that I have built is that the gear diff it's so good, and the new arms seem quite better
regards
I also had the side-to-side play but a couple of shims took care of it. I also got a CVD wheel axle which was to big to fit a bearing. I had to wet sand it to make the bearing fit. My LE went together without any quality issues.