Carpet set up
I have received quite a few PM's regarding a set up. Wannabe and I did some testing this week and this is what I ended up.
Front:
#3 piston - 50 wt. AE oil - puple spring
shocks inside on arm and laid in to third hold on tower
arm spacing (standard to the book settings)
4 degree "TC3" caster blocks
1.5mm up travel
camber link shimmed up one shim in to the third hole on brace
.62 sway bar
roll center = mid roll center = .050 spacers front and rear
Parma Cyan tires
Rear:
#3 piston - 40 wt. AE oil - copper spring
shocks outside on arm and in one on tower
arm spacing (standard to the book settings)
1.5mm up travel
camber link shimmed up one shim in to the fourth hole on brace and out on hub (full loooooooooooong)
roll center = mid roll center = .050 spacers front and rear
rear toe = used a front block for inner and the 3.0 block on rear
NO sway bar
Parma Magenta tires
Roll center - kit comes with three different sizes of shims. .025 - .050 and .075. I used the middle shims all around. They are the shims with the two triangles.
Rear toe - used the f blocks on the back. Just like we all did on the "TC3". If I remember correctly the f block is the one marked with an "0". Rear toe ends up at about 1.5 or so.
Tire size = 2.28
Parma Alfa body
Batteries forward