Originally Posted by
alex_evo
I used the procedure as on the manual.
1.transmitter on 2.hold down the set button(next to switch)3.turn esc on while holding down button until the led flashes.
When i do that, it flashes plus beeps as described. Throttle on neutral already and i should press the set button again, but nothing happens, red leds still flashing and beeping. Only way to stop it beeping is to turn it off
I used Carson reflex pro, etroniks pulse EX3 pro, Futaba 3PL
I would guess you have a bad switch/button assembly, if nothing else that you have tried has worked.
You said after going into TX setup that when you push the button to wet neutral nothing happens so that would be my guess. I have seen this before on all the brands that use that type of button.