Originally Posted by
steve eaves
What would I need to run the dcj on a tc6 not the .1 just got the car thanks
Buy the #31360 TC6.1 Steering Blocks, the #31358 TC6.1 Caster Blocks, four 5x10x4 bearings and the #31370 TC6.1 Axle Crush Tube. Then buy all the DCJ, pins and hexes from RSD...
Originally Posted by
kewdawg
Guys, other than RSD, what other brand of bladders will fit the TC6 shocks???
I think I heard that Tamiya bladders fit as well, but that was two years ago...
Today the Zeppin C-Hubs arrived from Finnland:
Good manufactoring quality as far as it is visible. They look a little weak. We will see if they can take some hits.
Unfortunately the UPS-man came late so I couldn't test them today. So you guys will have to wait at least one week for an inside report. Before I will post some more pics with the C-Hubs on the car and a feedback how they fit (slop, DCJ-fitting, and so on...).