Finished the prototype servo mount for a "no drill" direct fit on the TC6, TC6.1 and I think the TC6.1WC. It uses the existing weight mounting holes in the middle of the chassis.
I was previously using the Tamiya mount from CSO but this one is far more secure and doesn't require any drilling of the chassis. You may also notice that I provided a mounting point for the factory antenna mount as well which will free up some precious area on the chassis. There is plenty of room for even a standard sized servo. There should be no issues with the Savox fitment either.
Tell me what you think and if there is enough interest, I will produce it.