Originally Posted by
racer x 1
So im about 70% done with my R1 Build and as I was messing with my CVD's I noticed 3 of my 4 are drilled for the use of a set screw to hold the pin and the 4th is not.
as I now took a closer look at that one I noticed that, that cvd has MUCH more slop in the joint than the rest.
Disassembled the joint to find that all looks fine just tolerances being off. Can anyone aid me in getting a new 50mm cvd?
Contact spec-R directly. You might need to take a photo of it but im sure they would send a new part out to you