Hi all,
Here are some pics of my modded top plate. I made 2 versions. One that is the same strength and flex (approx) as the standard plate, and one that is alot stiffer. They are both 1mm thicker than the standard plate, because I wanted to achieve the same effekt as those who use spacers in the back.
I also made it cover up the servo abit. It suits no purpose, other than I had a little fun making it, and there was room for some stickers. I might make a new one, that is 100% symetrical on both sides. It all depends on wether I end up liking this one better or the standard look. Time will tell...
I made holes for 2 3Racing belt tensioners, and offset them 2mm from center, to make the belt run on the middle, instead of grinding against the aluminium post.
Tell me what you think guys, maybe I should switch back to the symetrical layout or???
Pics:
Standard flex, with cover.
Standard plate, and the upgraded stiff version, with cover.
Fitted with 3Racing tensioners, and some stickers.
Mounted on the car, no more belt slop!
I hope you alle have a Merry Christmas
