R/C Tech Forums - View Single Post - Schumacher Corner
View Single Post
Old 10-16-2004, 07:57 PM
  #7791  
Tony Rivas
Tech Elite
iTrader: (56)
 
Tony Rivas's Avatar
 
Join Date: Jan 2003
Location: Kissimmee, Fl
Posts: 2,310
Trader Rating: 56 (100%+)
Default

Originally posted by protc3
the upper and lower deck are 2.5 mm.the differences are the batt location is as close as possible to the centerline and moved forward(still need to test the forward position,its location may change from front to rear),chassis is much thinner,i removed some through pockets and replaced with partial pockets,and i smoothed the corners of the chassis so it was not so squared off.the upper brace is closed in the front and rear to eliminate bulkhead compression or pinching that causes tweak.here is a front side pic of the car.there is a funny glare on the upper brace pocket in the pic that i cant explain.in person you can not see it.
looks good to bad i cant try it out!
Tony Rivas is offline