Originally Posted by
Akhor
What was the result of this? Was it worth doing?
Its makes the only servo mount point down the center of the chassis. Raises the outer mount point 1mm higher then when using the stock mount so it gives better clearance on hard chassis roll situations, actually now the chassis rail hits before the servo touches. I've never gone back to the original once I did this mod, so its pretty bullet proof, no failures yet. Its very easy to do the only catch is getting the bottom plate material, from there 3 holes drilled in the plate and its done.
Was it worth it? I think its made the car just more consistent. It also allows you to run a servo saver without clearance problems. If you don't like the mod, nothing in the stock parts where modified, so you can always go back (don't think you will though).
If your going to the Airdrie WCIC race come over and you can see the mod.