Originally Posted by
dontfeelcold
Need some advice on motor and gearing choice. I will be running 10.5 Blinky and I have been told to run around 80mm rollout.
Are there any particular motors that standout in 10.5 blinky in 1/12th?
I am looking at using a 75t Xenon 64dp spur gear with 42t to 46t 64dp pinions. Will these fit? (CRC 1/12th)
Thanks
Josh
That sounds about right but I have only run boosted so not sure.
Thunder power, Reedy and D3.5
That should fit but will put the motor very close to the axle. A larger spur/pinion combo will move the motor forward and result in better handling.