Originally Posted by
mhavlena
Guys:
I installed V3 firmware within the programmer card and the ESC today. Everything worked fine when installing the firmware within the programmer card, but when attempting to install the firmware within the ESC, I got an error message even though it the install seemed complete. The error message had something to do with asking me to plug in the ESC...somehow the connection was, allegedly, lost.
In any case, I unplugged the ESC and re-plugged it and the USB link software indicated that the firmware was indeed V3 and everything OK. I scrolled through all the menus and everything seems fine.
Question:
Has this been experienced before? Should I re-flash the firmware just in case? Can I re-flash it?
Appreciate everyone's support!!
you can re-flash to the older version then again to the new version if you want to. it will not re-flash the same version.
also some new function on V3.0
you can read off the ESC after the run: max RPM, Lowest Voltage, and ESC temp