R/C Tech Forums - View Single Post - New LRP Flow Esc
View Single Post
Old 11-15-2012, 01:16 PM
  #116  
niemand
Tech Adept
 
Join Date: May 2009
Location: Germany
Posts: 165
Default How to remove the switch (properly)

Hey guys,

just got my FLOW. Got it all wired up and soldered the two wires of the on off switch together like I always do on my speedos. Then I wanted to test it. So I plugged a battery in. Nothing happened
Used a freshly charged battery, still no reaction.
I almost wanted to give it back to my LHS.
But before that I unsoldered the wires of the switch and tried again.
...and it worked

So just as a tip for those who want to remove the switch:
Just remove the switch and insulate the two wires.
DO NOT SOLDER THEM TOGETHER! (like i did)

Regards from Germany
niemand is offline