R/C Tech Forums - View Single Post - Spec-R R1
Thread: Spec-R R1
View Single Post
Old 11-14-2012, 07:10 AM
  #339  
Xenolance
Tech Adept
iTrader: (5)
 
Xenolance's Avatar
 
Join Date: Apr 2012
Location: Houston, TX, USA.
Posts: 174
Trader Rating: 5 (100%+)
Default

Originally Posted by grippgoat
Be careful with that. I haven't touched a VTA front in a while, but I vaguely remember them having somewhat shallow hexes. Just make sure the wheel is getting enough engagement on the actual hex to stay put if you tap a board.

-Mike
+1

This is why I suggested the wider Hex's initially instead of the washers. Isn't there two different sizes of VTA wheels allowed now, one being slightly larger? Not to mention, most VTA bodies are 200MM instead of 190, so the +.75 or +1.0MM hexes would push the wheels out to make it look better with a 200MM body.
Xenolance is offline