Originally Posted by
jlfx car audio
Is everyone building per kit suggestions . I really don't like the ball stud on inner links. Its only 4mm long and has a2mm shim in there also its scary. Think iI'm going to have to order some 6mm/8mm studs just to keep my mind at ease . ..
Has anyone tried running no shims under inside and 2mm outside in rear ?
And front 1mm inside and 0mm out side front ?
This would keep same link angles & length but lower them.
No, in the middle hole, and yes you will need longer ball studs on the bulk head side. My understanding is that lowering should give you more traction...