You need an extensive supply of tyres for this chassis just like a real drifter lol
Originally Posted by
tworrs
Hey
I was just wanting to make sure I'm doing something right before I do it, is it the axle with D44 printed on it that you take apart , then flatten down the centre of the pin, them return the grub screw with thread lock , going to build my chassis , just want to do this first,
Originally Posted by
eunique
Yes, your front CVDs..the pins have a tendency to slip out from the grub screw that is supposed to keep it in place in the shaft roller which holds the axle in place...or you can get those axle pin holders from the Sakura XI and slide them in place over. That will keep the pins from sliding out.
Doing the Dremel mod to flatten the pin is free though.
Not just the front CVD's do the pins on all the CVD's and replace your front CVD's with something with a wider angle that will help with the chatter
hey eunique I'll post some pics of my mounts with washers later.