Originally Posted by
speed6
Hey DJ,
could you kindly confirm
Rear bottom roll center block marked 2, what does that mean exactly?
Front Shock piston with one hole what size?
I also noticed that you run a screw in the left hand side on the upper tray next to the 25 gear, how come more stability at the cost of steering?
Thanks
There are 5 positions in the rear lower pins. The lowest is #1 and the highest would be #5. The middle would be #3. I was the position between the lowest and middle position.
There is only one size piston that I know of. They come in 1, 2, 3, 4, 5 or 6 holes. I use the 1 hole pistons in the front.
I have only tried not using the screw once and the car felt like it was not as consistent with the steering in the middle of the turn. So from that point on I always used the screw like it is stock from the kit. I have not felt like I need more steering for a while. I seem to have the steering I need at all the track I have been running lately.
DJ