Carpet Setup For The S2 From R/CTech Memeber 2Xs
This info should be helpful to begin with setting up the S2 for VTA Racing -
Many (belated) thanks to 2xs for his post.
From August 2010: R/C Tech Forums > General Forums > Electric On-Road VTA tuning Q&A
http://www.rctech.net/forum/electric...ning-q-33.html
OK Darkside here is my setup. This is for a small,50x30, track. This is a work in progress, but it hooks up well on our track. I have the CF chassis and shock towers installed. The main chassis was a huge improvement over the plastic chassis.
FRONT
Ride Height - 6mm
Droop - 2mm over ride height
Caster - 4*
Camber - -1.5*
Toe - 0*
Upper control arm - E
Shock location - 3B
Springs - HPI Pink (15.2#)
Oil/Piston - Trinity30/2 hole
REAR
Ride Height - 6mm
Droop - 1.5mm over ride height
Camber - -1*
Toe - -3*
Upper control arm - C2
Shock location - 3B
Springs - HPI Orange (12.1#)
Oil/Piston - Trinity30/2 hole
Made a couple changes to this setup and the car is a blast to drive now. Changes are in RED
FRONT
Ride Height - 5mm
Droop - 1.5mm over ride height
Caster - 4*
Camber - -1.5*
Toe - 0*
Upper control arm - E
Shock location - 3B
Springs - HPI Pink (15.2#)
Oil/Piston - Trinity30/2 hole
REAR
Ride Height - 5mm
Droop - 1.5mm over ride height
Camber - -1*
Toe - -3*
Upper control arm - C2
Shock location - 3A
Springs - HPI Orange (12.1#)
Oil/Piston - Trinity30/2 hole
Last edited by Marv; 08-18-2012 at 08:14 PM.