Originally Posted by
RedBullFiXX
When using the Aluminum Uprights
Run spacers on top of the upright to set ride height
Pull upright towards upper a-arm, and tighten grub screw on upright, this will remove any freeplay between the upright and a-arm for a consistent setup
Use shims to adjust droop on the lower a-arm droop screws
Note pic below for reference
See the VII link in my sig, all is explained there
I recommend the "off-set" axle setup, in most conditions this will be the most balanced
Is that your spring under the upright or is it under the lower arm