Originally Posted by
Kensei
Which spurs fit for this car?
Can't see any on RC Mushroom smaller than 83T.
I heard of someone buying these.
http://www.rc-mushroom.com/product_i...8-hard-p-19070
Or these maybe?
http://www.rc-direct.co.uk/-c-60_235.html
Any suggestions?
Which spur is in the kit? I mean how many teeth?
Can I combine this spur gear with pinion gears to get me FDR between 3.0 and 5.0?
I mean the pinions will be quite large that way, knowing that the IR is 2.0 and the spur gear in the kit will be about 83T (or more).
I mean is there enough space for that spur and pinions that large to get me these FDR's and get them meshed the right way?
What about the weight of the car. It must be easily be below 1,350gr. If not, it's a no go for me.
What is the rear toe in with the alu suspension brackets 0, 1, 2, 3?
Do the dots mean degrees?
The manual says FR1 and FF2. That would be 1 degree toe out than?
The manual says RR3 and RF0. That would be 3 degrees of toe in than?
The kit spur is 84T 48Dp
The 'xray' spur gears from rc-direct are ideal, using them myself but the 64Dp.
If using 48Dp you will not get as low as 3 FDR using the kit spur, you will need to go smaller, no problem to get 5 FDR. There is no space problem with 64Dp spur/pinion.
Weight of my car using standard sized servo, motor cooler, 0.8mm bodyshell,shorty lipo and including transponder comes to 1365g. Could probably loose a few grams with neater/shorter wiring.
Yes dots mean degrees, so your toe in/out is correct.
Hope this helps. Overall am very pleased with this car, kit built well,good quality parts, worked well with kit setup. Running it as 17.5T blinky, easily as good as my S411, probably better.