I'm running a 47t pinion. It seems that I have to take the spur gear off just to get the motor screw on. And it seems that I need to take to spur off just to tighten the motor screw. I'm running 96t spur. The motor screw does not seem to align with the hole in the spur.
To add to my questions. I am using the airtronics mt4 with spectrum low profile servo. It seems that to get close to full steering, i need to set my EPA to 150 (max of the controller). Is this right? and my servo is like 0.08 secs. It doesn't seem that fast. I am thinking because it has to go full throw (almost 180 from left to right).
Am i doing anything wrong?
Last edited by teeforb; 06-24-2012 at 01:51 PM.