Originally Posted by
kdempsey
Is anyone having trouble with the logging function? My Esc temp reads ok, Motor temp I use ThunderPower motors so not sure if these will work for this function but it reads 0 after a run, Min battery voltage is always 12.6v and my motor RPM is reading 68,000rmp...on a 10.5 motor ????
I am switching it off by the button after a run, plugging in program box, switch ESC back on again and taking reading then, I think this is correct..
Thanks,
Keith
Sizheng replied about the voltage 2 posts above you, never seen the motor cut off work for any motors yet tbh. My rpm log was recording reasonable rpms, my 4.5t got 64000 which worked out to be 105 kph if my math was correct. What fdr were you running?