Originally Posted by Max K

I would start with my setup from reedy. Me and Dave were running basically the same setup and it worked very well!

Front Setup:
3rd from most inner hole
outer most hole on lower shock mount
40wt oil
hole drilled in shock cap
25% rebound
1.24mm swaybar
xray ecs drive shafts
.5mm wheel spacer
2mm spacer in back of arm for wheel base thick up front
2mm shim under inner link
0 shims under arm mounts
VBC Pink spring
-2 camber
6 droop
5mm ride height
Gear Diff 300,000

Rear Setup:
3rd front inner most hole
outer most hole on lower shock mount
35wt oil
hole drilled in shock cap
25% rebound
1.20mm swaybar inner mount position on arm
2mm shim under outer link
2mm shim under inner link
all shims forward on rear wheel base
0.5mm shim under front and rear block
VBC Blue spring
-2 camber
2 droop
5.25mm ride height
Gear Diff 1000

Took 2 screws out of top deck behind spur gear (helped rear end flex more)
Protoform LTCR Body
body roof height just slightly higher than ROAR Rule

I would start with a spool in the front tho. Thats the only thing I would change to start