R/C Tech Forums - View Single Post - CRC 1/10 Pan Car
Thread: CRC 1/10 Pan Car
View Single Post
Old 06-06-2012, 10:48 AM
  #2865  
andrewdoherty
Tech Elite
iTrader: (49)
 
andrewdoherty's Avatar
 
Join Date: Jan 2005
Location: ★Wylie, TX★
Posts: 3,815
Trader Rating: 49 (100%+)
Default
Originally Posted by TyoBBS
OK thanks.

I saw some videos (i only found off-road) and they left the car since some cm on the table.

I think we need to move front part (push down). To set front sring at "0 position" = check camber. Is true?


regards

Correct. Get the car race ready, and then push down on the chassis and release to get the car to sit "neutral". I usually just push down in the middle of the car.
andrewdoherty is offline  
Reply