R/C Tech Forums - View Single Post - CRC 1/10 Pan Car
View Single Post
Old 06-05-2012, 09:24 PM
  #2862  
CypressMidWest
Tech Elite
iTrader: (1)
 
CypressMidWest's Avatar
 
Join Date: May 2003
Location: Central Ohio
Posts: 4,617
Trader Rating: 1 (100%+)
Default

Originally Posted by TyoBBS
Usually i check the camber:
Pushing the car until touch car the floor and then leave alone it. In this way i check de camber

But after 42minutes in the track i check diameter of the tyre and is less outside! = positive camber!

How i need to check the camber?

In the air?
In the floor but without pushing the car?


thanks and regards
Check camber with the car fully loaded and ready to run on your set-up board. This method ensures that all your settings are true based on how the car will sit under race conditions.
CypressMidWest is offline