Originally Posted by
klth
Anyone ever experienced with the wear on the rear dogbone as shown in the attached picture?
Kit: T3 2012
Rear Gear Diff with stock Alu outdrive
Dogbone: 50mm
Rear Toe: Inboard 3 Degree Toe in
I never find this problem before on any other previous xray kit. It is obvious that the 'ball' of the dogbone rubs against the inner wall of the Alu outdrive. The option spring steel gear outdrive is slotted, can changing the spring steel one improve the problem?
Thanks very much!
Dont have my t3 2012 kit anymore so I could be wrong but isnt the rear meant to be the 52mm bone? Could it not be far enough in the outdrive and wearing due to slop?
Simon