has anyone had a problem with the front solid composite axle assembly? I just got a 2012 T3 kit and while trying to assemble the front solid composite axle I found that the screws the instructions tell you to use to tighten down the outdrives into the composite axle just drop right in and fall right out of the axle, they do not grab anything. Is the front axle hole supposed to be threaded because mine is not. I tried contacting xray but they just seem to not read my emails very well and they are trying to blame me for over tightening the screw but the screw never grabbed to begin with so I'm not sure how I can strip a hole that the screw never grabbed in to begin with, either that or the screws they sent were the wrong size and after putting my caliper on them, the screw measured 2.95 instead of 3mm, but I would think that's not enough of a difference to not grab at all. Has any one else ran into this problem?? Is the front axle supposed to be threaded inside ??
