Cheers for that, I'm deffiently going to give that a shot with the Savox when my TQ order turns up.
Anyway, latest install at the moment... waiting on a few more bits to arrive, but I am digging the red motor wire, matches the batt good (and only reason I used it was had run out of black!!)
Fan wire needs tidying up, but difficult to route... any ideas? Otherwise, ESC wire needs lengthening to allow better routing, but given it's a HW V3, once it's in the Rx, never needs to come out again as all programming is done via the front port! And the inbuilt switch (with back lit LED) is pimp!
Ed