Originally Posted by
zaraz
so, its safe to assume that the arrowmax ecs use the same pin size as the xray ecs, 1.5x8 in board and 1.5x9 out board, would this be correct thanks
Yes the Arrowmax ecs' use the same length pins as the X-Ray...Although this past Sat. at the Hurricane race in Indiana I used the 1.5X9 pins (as I did not have the shorter length pins) for the entire ECS. clearance was tight, but as long as you are using the ground flat spot pins you should be fine...I triple checked to make sure that there was not any binding issues with the extended pins by compressing the arms and by also turning wheels to full lock right and left...a dremel could alleviate this issue, but I had enough clearance for this to not be a problem.